Installation Guide Owner's manual

INSTALLATION
Routing Cables
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-31
ACCESSING THE CPI
The CPI comes wired and ready to install. Should you need to re-route the cables so
they come out a different side of the box, use the following instructions to access the
CPI box.
1 Turn off the power to the dyno. Refer to “Main Dyno Power” on page 3-2 for more
information.
2 Remove the eight button-head screws securing the cover and set aside.
3 Remove the cover and set aside.
4 Open the front panel to access the breakers and Breakout board.
Figure 2-25: Accessing the CPI
PD027
cover
front panel access