Installation Guide Owner's manual

INSTALLATION
Blower and Monitor Support Installation
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-21
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BLOWER AND MONITOR SUPPORT INSTALLATION
Use the following instructions to install the blower mounts, monitor support, and
junction box along with the high pressure blower assemblies and monitor tray.
You will need the following parts:
• 21221500 Blank Plate, Junction Box
• 21228000 Junction Box Base
• 61329101 Monitor Tray
The following parts are included in the Monitor Support P/N 61329003
• 26215520 Washer, 1/8", Poly (3)
• 35521420 Cap Plug (4)
• 61329100 Monitor Arm (2)
• 61329500P Monitor Support
The following parts are included in the Blower Assembly P/N 76722005:
• 21600015 Lower Blower Arm (2)
• 26215220 Washer, 3/8", Metal (2)
• 26215520 Washer, 1/8", Poly (4)
• 26215521 Washer, 1/4", Poly (4)
• 35521420 Cap Plug (8)
• 35712991 Clamp Lever (2)
• 37513200 Anchor, Redhead, 3/8" (8)
• 61328101 Blower Housing Assembly (2)
• 61329601 Blower Mount (2)
• 63413001 Upper Blower Arm (2)
• DM150-002-007 Washer, 5/16", Flat (8)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (8)