Installation Guide Owner's manual

INSTALLATION
Carriage Plate and Tire Carriage
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-19
2 Use the carriage plate to mark and drill mounting holes as shown in Figure 2-14.
2a Using the carriage plate as a template, mark and drill four 1/2-inch holes.
2b Install the Red Head anchors. Refer to Appendix A for installation
instructions.
Figure 2-14: Carriage Plate Mounting Dimensions
3 Secure the carriage plate to the floor using four 3/8 x 1-inch bolts and
5/16-inch washers.
Figure 2-15: Install the Carriage Plate
66.04 cm
(26.0 in)
40.32 cm
(15.875 in)
PD156