Installation Guide Owner's manual

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
CHAPTER 2
Carriage Plate and Tire Carriage
2-18
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CARRIAGE PLATE AND TIRE CARRIAGE
Use the following instructions to install the standard carriage or optional extended
carriage.
The tire carriage is fastened to the bottom of the crate next to the dyno. Refer to page
2-2 for instructions on removing the tire carriage from the crate.
You will need the following parts:
• 37513200 Anchor, Redhead, 3/8" (4)
• 37518200 Installation Tool, Redhead Anchor
• 71323006 Standard Carriage
71323007 Extended Carriage
• DM150-002-007 Washer, 5/16", Flat (4)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)
INSTALLING THE CARRIAGE PLATE
1 Remove the four bearing plate screws and slide the carriage from the carriage
plate.
Figure 2-13: Remove the Carriage From the Carriage Plate
TC062
carriage plate
carriage screw
nut block
bearing plate
screws