Installation Guide Owner's manual

INSTALLATION
Dyno Drum Module Installation
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-9
PLACING THE DYNO IN THE PIT
Place the drum module in the pit as shown.
Note: This installation has been designed for the eddy current brake to be
installed on the left side of the dyno. Contact Dynojet for information regarding
installation on the right.
Figure 2-3: Drum Module Placement in Pit—Left Side Eddy Current Brake
Figure 2-4: Drum Module Placement in Pit—Right Side Eddy Current Brake
15.24 cm
(6.00 in)
7.62 cm
(3.00 in)
15.24 cm
(6.00 in)
7.62 cm
(3.00 in)