Installation Guide Owner's manual

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
CHAPTER 2
Dyno Drum Module Installation
2-8
REMOVING THE DYNO FROM THE CRATE
This section will walk you through removing the dyno from the crate and installing
the dyno in your pit.
You will need to provide equipment capable of lifting a minimum of 1,089 kg.
(2400 lb.) to lift the dyno (drum module) off the crate and into position in your dyno
room. You will also need a pair of straps capable of supporting 1,089 kg. (2400 lb.) to
attach to the dyno. Dynojet recommends using a single loop style strap.
#
RECORD
Be sure you record the dynamometer number on the inside cover of this
manual.
1 Remove the four lag bolts and washers securing the drum module to the crate
base using a 9/16-inch socket, open or box end wrench.
2 Wrap the single loop straps around the drum module shaft.
3 Lift the drum module off the crate and move into position in your pit.
Figure 2-2: Remove the Dyno From the Crate Base
dyno number
stamped on frame
(not visible)