Installation Guide Owner's manual

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
CHAPTER 5
Loading the Motorcycle
5-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOADING THE MOTORCYCLE
Use the following steps to load a motorcycle on the dyno.
Keep the motorcycle balanced while driving on and off the dyno.
Risk of injury. Always wear proper eye and ear protection when operating the
dyno.
1 Load the motorcycle on the dyno.
2 Place the bike on the dyno so the front tire is in the tire stop.
3 Strap the front wheel to the tire stop and tighten.
Note: If you have the wheel clamp, use the control panel to secure the front
wheel.
Never perform a dyno run if the tire strap is not in place or is damaged.
4 Use the control panel to run the power carriage until the rear axle is aligned with
the center of the drum.