©2004 Dynojet Research, Inc. All Rights Reserved. Folding Ramp Installation Guide For Model 200i and 250i Motorcycle Dynamometers. This manual is copyrighted by Dynojet Research, Inc., hereafter referred to as Dynojet, and all rights are reserved. This manual is furnished under license and may only be used or copied in accordance with the terms of such license. This manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Dynojet.
TABLE OF CONTENTS Folding Ramp Installation Conventions Used In This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Removing the Ramp from the Crate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Installing the Ramp on the Dyno . . . .
FOLDING RAMP INSTALLATION This document provides instructions for installing the folding ramp assembly to the Dynojet model 200i/250i motorcycle dynamometer (dyno). To ensure safety and accuracy in the procedures, perform the procedures as they are described.
FOLDING RAMP CONVENTIONS USED IN THIS MANUAL The conventions used in this manual are designed to protect both the user and the equipment. example of convention description The Caution icon indicates a potential hazard to the dynamometer equipment. Follow all procedures exactly as they are described and use care when performing all procedures. The Warning icon indicates potential harm to the person performing a procedure and/or the dynamometer equipment.
INSTALLATION GUIDE Installation INSTALLATION ................................... The folding ramp allows you to easily and safely load motorcycles onto the dyno. This section will walk you through removing the ramp from the crate and installing the ramp on model 200i and 250i motorcycle dynos. REMOVING THE RAMP FROM THE CRATE 1 Remove the crate top.
FOLDING RAMP Installation 2 Remove the crate braces. crate braces Figure 2: Remove the Crate Braces 3 Remove the 2x2 brace securing the ramp down.
INSTALLATION GUIDE Installation 4 5 6 Fold the ramp up. Remove the front crate panel. Remove the braces.
FOLDING RAMP Installation 7 Remove the two bolts and washers securing the ramp assembly to the crate. Only one bolt and washer will be visible from this view.
INSTALLATION GUIDE Installation 8 Remove the ramp by sliding it from the front of the crate. Dynojet recommends using two people to remove the ramp from the crate.
FOLDING RAMP Installation INSTALLING THE RAMP ON THE DYNO 1 Lower the ramp by pressing on the ramp release with your foot and using the hand knob to gently lower the ramp to the floor. Be sure to have someone hold the ramp assembly while lowering the ramp to prevent the assembly from rotating.
INSTALLATION GUIDE Installation 2 Remove the four 1/4-inch button-head bolts from the top of the dyno. 3 Remove the two 3/8-inch button-head bolts from the back of the dyno.
FOLDING RAMP Installation 4 Slide the ramp up to the dyno. 5 Secure the top of the ramp to the dyno using the four button-head bolts removed earlier. Secure the sides of the ramp to the dyno using the two button-head bolts removed earlier.
