User Manual

INSTALLATION GUIDE

Installation

Version 3 DynoWare EX+ Upgrade Installation Guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INSTALLATION

The DynoWare EX+ system is comprised of four modules: the CPU Module, the

Dynamometer Input/Output Module, the RPM Module and the Atmospheric Sensing

Module. The upgrade requires a new pickup card and Breakout board (the interface

between the dyno and the new DynoWare EX+ hardware). This section will provide

you with the information necessary to install and connect the new components. If you

have an air brake you will need to make additional modifications; refer to “Air Brake

Modifications” on page 7 for more information.

Figure 2: DynoWare EX+ Modules

REMOVING THE HOOD

1 Disconnect all power to the dyno.

2 Remove the four bolts securing the hood to the dyno.

3 Prop up the hood and disconnect all battery wires.

4 Remove the hood.

Figure 3: Remove the Hood

atmospheric

sensing module

RPM module

dynamometer

input/output module

CPU module