User Manual

INSTALLATION GUIDE
Installation
Version 3 DynoWare EX+ Upgrade Installation Guide
9
INSTALLING THE BREAKOUT BOARD
1 Install the four rubber vibration dampening mounts to the Breakout board using
four No. 8 nuts.
Figure 13: Install the Vibration Dampening Mounts
2 Secure the Breakout board cover and board to the dyno using four No. 8 screws.
Note: Be sure the large data plug on the Breakout board is facing towards the
front of the dyno (away from the drum).
Figure 14: Secure the Breakout Board and Cover
breakout board
nuts
dampening
mounts
Breakout board
and cover