User Manual

INSTALLATION GUIDE
Installation
Version 3 DynoWare EX+ Upgrade Installation Guide
5
INSTALLING THE PICKUP CARD
1 Remove the two 5/8-inch nuts and washers from the bearing case and set aside.
2 Remove the existing pickup card bracket.
3 Install the new pickup card bracket and secure the bracket using the two 5/8-inch
washers and nuts removed earlier.
4 Torque the nuts to approximately 150 ft. lb.
Note: If you have a high inertia drum, install the extender bracket on your
existing pickup card bracket.
Figure 6: Install the Pickup Card Bracket
5 Install the new pickup card in the notch on the new bracket using two
No. 8 screws and lock washers. Do not tighten, the card must be aligned first.
Figure 7: Install the Pickup Card
extender bracket for
high inertia drums
pickup card bracket