User Manual

DynoWare EX+ Upgrade Installation Guide
DYNOWARE EX+ UPGRADE
Installation
4
REMOVING THE ORIGINAL HARDWARE
1 Disconnect the cables from the existing pickup card.
Figure 4: Disconnect the Cables from the Pickup Card
2 Disconnect the cables from the RPM box, if present.
3 Remove the cable clamps securing the wiring harness under the front dyno cover.
4 Remove the old cables. Be sure to leave the starter cable in place.
5 Remove the RPM box, if present.
5a Remove the nut and washer from the vibration dampening mount on the
right side of the RPM box.
Note: This dampening mount will remain in place due to the difficulty of
removing the screw that secures it to the frame.
Figure 5a: Remove the RPM Box
5b Remove the two screws securing the two remaining dampening mounts and
remove the RPM box.
Figure 5b: Remove the RPM Box
6 Remove the two screws securing the pickup card and remove the card.
RPM box
dampening mount
screws
this dampening mount
will remain attached