Installation Guide User Manual

INSTALLATION
Dyno Installation
Version 4 Above Ground Model 224 Automotive Dynamometer Installation Guide
2-5
PLACING THE DYNO IN FRONT OF THE LIFT
1 Verify that the interface bracket faces the lift as shown in Figure 2-2.
2 Verify that the lift is in the down position.
3 Use the forklift to position the dyno in front of the lift. The dyno should be about
10.1 cm (4.00 in.) from the lift cross member.
4 Center the dyno drum with the lift runways.
5 Gently lower the dyno into position.
Figure 2-2: Dyno with Lift
AD214
lift runway
lift runway
cross member
interface bracket
10.1 cm
(4.00 in.)