Installation Guide Instruction Manual

In Ground Model 224 Automotive Dynamometer Installation Guide
CHAPTER 2
Pit Cover Installation
2-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PIT COVER INSTALLATION
Before installing the pit covers, be sure you have routed any cables and connected
your shop air. If you ordered the CE drum guards, install them before securing the pit
covers. Refer to the CE Package Installation Manual (P/N 98295112).
Note: If you did not order the pit cover set, you will not have pit covers.
You will need the following parts:
• 21216502P Side Pit Cover (2)
• 36582034 Bolt, 3/8-16 x 1.25", Button-head Flange, Allen (16)
• 61245100 End Pit Cover (2)
• 79190001 Ground Hook Kit (10)
INSTALLING THE PIT COVERS
1 Install each end pit covers to the dyno using one 3/8-16 x 1.25" button-head
flange bolt.
Figure 2-7: Install the End Pit Covers
bolt
end pit cover