Manual

Model 224 Pit Eddy Current Brake Installation and User Guide
CHAPTER 1
Introduction
1-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
Before installing your eddy current brake, please take a moment to read this guide for
installation instructions and other important information.
This guide is designed to be a reference tool in your everyday work and includes the
following chapters and information:
EDDY CURRENT BRAKE INSTALLATION
This chapter describes the procedures for installing the eddy current brake.
TORQUE MODULE INSTALLATION
This chapter describes the procedures for installing the torque module and load cell
along with load cell calibration.
BASIC DYNO OPERATION
This chapter describes basic dyno operating procedures.
RED HEAD INSTALLATION
This appendix describes the procedures for installing the Red Head anchors.
POWER REQUIREMENTS—EXCLUDING NORTH AMERICA
This appendix describes the power requirements and installation instructions for all
locations excluding North America.
INSTALLING THE ADAPTER AND BEARING—EARLY MODEL DYNOS
This appendix describes the procedures for installing the adapter and bearing needed
for early model dynos.