Manual

EDDY CURRENT BRAKE INSTALLATION
Eddy Current Brake Installation
Version 2 Model 224 Pit Eddy Current Brake Installation and User Guide
1-15
INSTALLING THE PIT COVER SUPPORTS AND THETA CONTROLLER
1 Loosely secure the pit cover supports to the frame using two 1/4-20 x 3/4-inch
button-head flange screws for each support.
Note: Do not tighten the screws.
2 Verify the pit cover supports are flush with the top of the pit floor before you
tighten the screws.
2a Place a straight edge across the pit cover supports.
2b With the pit cover supports tight against the straight edge, tighten the
screws.
Note: You can use c-clamps to attach the upright to the straight edges to make
this quicker. Tighten the c-clamps until the pit cover supports are flush with the
pit floor.
2c Remove the straight edge.
Figure 1-11: Install the Pit Cover Supports
pit cover
supports