Installation Guide Owner's manual

BASIC DYNO OPERATION
Connecting the RPM Pickup
Version 3 In Ground Model 224 4WD Automotive Dynamometer Installation Guide
4-7
CONNECTING THE PRIMARY INDUCTIVE PICKUP
The primary inductive pickup cannot be in contact with, or it’s connecting wire be
crossing, other engine electrical wires or stray RF interference may result.
1 Clip the primary inductive pickup around the primary side of the coil.
2 Route the primary wire cable clear of devices that produce electronic noise.
Note: You must ground the vehicle to the dyno for the electronics to function
properly.
Figure 4-5: Primary Inductive Pickup
connect primary
inductive pickup on the
negative side of the coil
coil