Installation Guide Owner's manual

BASIC DYNO OPERATION
Loading the Car
Version 3 In Ground Model 224 4WD Automotive Dynamometer Installation Guide
4-3
8 Attach the tie-down straps.
Rear Wheel Drive
• Attach two tie-down straps from secure anchor points to the rear of the
vehicle. Attach additional tie-down straps from the rear of the vehicle as shown
in Figure 4-2.
• Attach two tie-down straps from secure anchor points to the front of the
vehicle.
Front Wheel Drive
• Attach two tie-down straps from secure anchor points to the rear of the
vehicle.
• Attach two tie-down straps from secure anchor points to the front of the
vehicle. Attach additional tie-down straps across the front of the vehicle to
form a crisscross.
Four Wheel (All-Wheel) Drive
• Attach two tie-down straps from secure anchor points to the rear of the
vehicle. Attach additional tie-down straps across the rear of the vehicle to form
a crisscross.
• Attach two tie-down straps from secure anchor points to the front of the
vehicle. Attach additional tie-down straps across the front of the vehicle to
form a crisscross.
Figure 4-2: Attach the Tie-down Straps
rear wheel drive
front wheel drive
four wheel drive