Installation Guide Owner's manual

INSTALLATION
Grate Placement and Installation
Version 3 In Ground Model 224 4WD Automotive Dynamometer Installation Guide
2-27
INSTALLING THE SIDE GRATES
The side grates do not secure to the dyno.
1 Lay the side grates on the side of the dyno with the bolt holes on the outside.
2 Center the side grates with the pit opening.
3 Verify there is a one inch gap between the side grates and the center grates.
4 Verify the side grates do not touch the dyno or the center grates.
5 Mark and drill the ten holes needed to secure each side grate to the pit floor.
6 Install the Red Head anchors. Refer to Appendix A for installation instructions.
7 Secure each side grate to the pit floor using ten bolts, lock washers, and flat
washers.
Figure 2-24: Installing the Side Grates
side grate
mark and
drill holes
one inch gap
between grates
center grate
center grate with
pit opening
bolt holes on
outside