Installation Guide Owner's manual

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
CHAPTER 2
Grate Placement and Installation
2-24
INSTALLING THE CROSS BRACE ASSEMBLIES
Each cross brace assembly has two halves that must be assembled together before
installing the cross brace assemblies in the pit.
1 Loosely connect the two halves of each cross brace using three 3/8-inch bolts.
2 Slide the brace halves apart until the assembly is the same width as the pit.
3Tighten the bolts.
Figure 2-21: Connecting the Cross Brace Halves
width of pit