Installation Guide Owner's manual

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
CHAPTER 2
Chain Installation
2-20
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CHAIN INSTALLATION
Use the following instructions to install the chain assembly.
1 Secure the two idler sprockets to the cradle assembly using one
grade 5, 1/2-13 UNC x 1.5-inch bolt and spacer each as shown in Figure 2-17.
Note: The bolts, sprockets, and spacers will be packaged together.
Figure 2-17: Install the Idler Sprockets
idler
sprocket
bolt
spacer
cradle
assembly