Installation Guide Owner's manual

INSTALLATION
Dyno Installation
Version 3 In Ground Model 224 4WD Automotive Dynamometer Installation Guide
2-7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNO INSTALLATION
With the track assembly installed and secured to the pit floor, you are ready to install
the 224 4WD dyno.
REMOVING THE DYNO FROM THE CRATE
You will need to provide equipment capable of lifting a minimum of 1588 kg
(3500 pounds) to lift the dyno off the crate and into position in your dyno room. You
will also need a pair of straps capable of supporting 1588 kg (3500 pounds) to attach
to the dyno. Dynojet recommends using a single loop style strap.
1 Route the single loop straps around the knurled part of the drum as shown.
Figure 2-5: Loop Strap Placement
loop strap
drum