Installation Guide Owner's manual

INSTALLATION
Track Assembly
Version 3 In Ground Model 224 4WD Automotive Dynamometer Installation Guide
2-5
INSTALLING THE TRACK ASSEMBLY
Once all the holes are marked and drilled, install the track assembly.
1 Layout the first and last rail tie assemblies and the rail ties. Use the holes you
marked and drilled for placement of the rail tie assemblies and rail ties.
Note: The first rail tie has two holes for securing the cable track assembly. Verify
this rail tie assembly is closest in the pit to the stationary dyno.
2 Place the rail clamps over the rails.
3 Place the rails into the rail tie assemblies.
Note: For clarity, the pit is not shown.
Figure 2-3: Install the Track Assembly
rail clamps
rail
first rail tie
assembly
last rail tie
assembly
rail tie
holes for cable
track assembly