Installation Guide User Manual

Motorcycle Dynamometer Installation Guide
CHAPTER 3
Mechanical Brake
3-30
INSTALLING THE ROTOR/TAPER LOCK ASSEMBLY
1 Remove the hood. Refer to “Removing and Replacing the Hood” on page 3-3.
2 Insert the key into the slot on the shaft.
3 Slide the rotor/taper lock assembly on to the shaft.
Figure 3-37: Install the Rotor/Taper Lock Assembly
4 Attach the dial indicator to the side of the dyno. Spin the drum and check for run
out; the tolerances are +/- .005".
5 Tighten the taper lock bolts. While tightening, adjust the bolts to keep the run out
within tolerances. Torque the taper lock bolts to 15 ft. lb.
Figure 3-38: Check for Run Out
key
shaft
rotor/taper lock
assembly
dial indicator
taper lock bolts
(two visible here)