Installation Guide User Manual

OPTIONAL ACCESSORIES
Mechanical Brake
Version 3 Motorcycle Dynamometer Installation Guide
3-29
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MECHANICAL BRAKE
The mechanical or manual brake is a foot actuated hydraulic brake. The mechanical
brake can be utilized to quickly slow the drum after a run is complete. This is
especially useful for two-stroke applications when engine compression cannot be
used to slow the drum. The brake can also greatly speed up the testing process.
The following installation instructions are for the model 200 dyno; however, the
mechanical brake may be installed on model 100 and 150 dynos with proper
modification. Contact Dynojet Technical Support for more information about model
100 and 150 dyno modifications
To prevent possible injury, disconnect the battery before performing any dyno
maintenance or installing any optional accessory.
PARTS LIST
The following table lists all of the parts included in the Mechanical Brake Installation
kit. Check your kit against the parts listed to make sure you have received all of the
parts. If any part is missing, contact Dynojet Technical Support.
part number description quantity
63990001 Caliper Assembly 1
63990002 Rotor with Hub, Taper Lock, and Key 1
BR102-009 Mechanical Brake Pedal Assembly 1
BR102-029 Brake Spring Plug 1
— Rubber Boot 1
BR102-033 Grommet 1" OD, 3/8" ID 1
BR102-041 Master Cylinder 1
BR102-046 Brake Line 1
DE100-134 Screw, #8 x 1/2”, Self Tapping 2
DM150-035 1/2" Cable Clamp, Nylon 2
DM150-011-002 Washer, 3/8" Flat 4
DM150-011-003 Washer, 3/8" Lock 4
DM150-011-006 Bolt, 3/8 x 1 1/4", Hex 2
DM150-019-012 Bolt, 3/8 x 1", Hex 2