Installation Guide User Manual

OPTIONAL ACCESSORIES
Extended Carriage
Version 3 Motorcycle Dynamometer Installation Guide
3-27
3 Using a straight edge, line the top of the support bracket with the top of the dyno
chassis.
4 Tighten all six mounting bolts to 30 ft. lb.
5 Install the top cover on the dyno using the eight screws removed earlier. Refer to
Figure 3-33.
6 Install the two rear clamps to the dyno cover using the bolts and washers
removed earlier. Refer to Figure 3-32.
7 Using the original shim and the large shim included with the kit, loosely attach
the nut block to the front of the extended carriage support bracket using two
5/16 x 1 1/2-inch bolts, the flat washers you removed earlier, two 5/16-inch lock
washers, and two 5/16-inch nuts.
8 Using the original shim and the small shim included with the kit, loosely attach
the front clamp to the front of the extended carriage support bracket using two
5/16 x 1 1/2-inch bolts, the flat washers you removed earlier, two 5/16-inch lock
washers, and two 5/16-inch nuts.
Figure 3-35: Install the Nut Block and Front Clamp
nut block
front clamp