Installation Guide User Manual

OPTIONAL ACCESSORIES
Air Brake
Version 3 Motorcycle Dynamometer Installation Guide
3-11
INSTALLING THE AIR HOSE
1 Install the 1-inch grommet into the hole shown in Figure 3-17.
2 Wrap the push lock fitting with thread tape. Refer to Figure 3-18.
3 Insert the five foot section of air hose through the hole. Leave enough air hose
exposed and attach it to the regulator.
Figure 3-17: Secure the Air Hose to the Regulator
grommet
run air hose
inside dyno
attach air hose to
regulator