Installation Guide User Manual

DYNO INSTALLATION AND SETUP
Pickup Card
Version 3 Motorcycle Dynamometer Installation Guide
1-11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PICKUP CARD
The pickup card is an electronic circuit board that accurately senses each drum
revolution.
INSTALLING THE PICKUP CARD
1 Locate the pickup card bracket on the right side of the dyno just ahead of the
drum.
2 Install the new pickup card in the notch on the new bracket using two
No. 8 screws and lock washers. Do not tighten, the card must be aligned first
Make sure the side of the card with the optical pickup faces the back of the dyno.
Refer to Figure 1-14.
Figure 1-13: Attach the Pickup Card to the Bracket
3 Align the optical pickup card with the tab on the dyno drum axle. Once aligned,
tighten the screws to secure the pickup card in place.
The optical pickup is very delicate. Be careful not to damage the optical pickup
during alignment.
Figure 1-14: Align the Pickup Card
pickup card
bracket
pickup card
tab on dyno
optical pickup