Installing the Dyno Drum Cover for the Kart / ATV Dyno M/C Option Dynojet Research, Inc. 200 Arden Dr.
Drum Cover Installation This manual explains the installation procedure for the drum cover. The drum cover is necessary for the Kart / ATV Dyno when used in conjunction with Motorcycle Carriage Option. Step 1 Place the Drum Cover on the top deck of the dyno. It should cover the drum that it not used during motorcycle testing. Step 2 Use a tape measure to center the Drum Cover. Measure the front and rear of the cover to the front and rear of the dyno frame (A).
Step 3 Use a hammer and a transfer punch to mark the two holes for the retaining pins. The two holes are opposite of each other and near the corners. Mark the two holes here: Step 4 Remove the cover and drill the marks that you made with a 1/4” bit. Step 5 Replace the cover and line up the holes. Install the push pins through the cover and into the dyno top deck. Install the push pins Note: Never operate a motorcycle on the dyno with the drum cover removed.
