Manual

Document #98232100 11
Connect The Retarder to the Dyno
Step 1
Place the retarder next to the dyno so that the 8
holes in the connecting arms meet the 8 holes in
the dyno frame.
Step 2
Using eight
3
/
8
"x
3
/
4
" bolts and washers
(supplied), bolt the connecting arms to the dyno.
Leave the bolts loose! Do Not Tighten yet.
Note: You must use the
3
/
8
“ x
3
/
4
” bolts with a
flat washer when connecting the arms to
the dyno. Failure to use the specified bolts
and washers will cause interference with
the dynamometer drum.
Note: The bolts that secure the arms to the dyno
should have blue lock tight on them.