User's Manual

Control Panel Interface Installation and User Guide

1-1

C HAPTER

ONTROL

ANEL

NTERFACE

NSTALLATION

This document provides instructions for installing and using the Control Panel

Interface (CPI) with the model 200ip/250ip motorcycle pit dynamometer. To ensure

safety and accuracy in the procedures, perform the procedures as they are described.

This manual will walk you through installation procedures, basic operation, and how

to maintain and troubleshoot your hardware. Appendix A contains instructions for

installing the Red Head Anchors. Appendix B contains instructions for installing the

motorized carriage and wheel clamp. Appendix C contains instructions for installing

the safety switch should your country require one.

Document Part Number: 98225109

Version 1

Last Updated: 01-21-05

This chapter is divided into the following categories:

•Introduction, page 1-2

• Battery, page 1-7

• Blower Mounts, Support Arm, and Junction Box, page 1-10

• Routing Cables, page 1-14

• Junction Box Cover, Cable Cover, and End Cap, page 1-27

• Testing the Motorized Carriage and Wheel Clamp, page 1-29