Pest Control Equipment User Manual

CONTROL PANEL INTERFACE INSTALLATION
Routing Cables
Version 1 Control Panel Interface Installation and User Guide
1-23
ROUTING THE EDDY CURRENT BRAKE, BATTERY, AND DYNO POWER CABLES
1 Route the eddy current brake cable (P/N 66952005) from the eddy current brake
through the designated power pit conduit and to the theta controller.
2 Route the battery cable (P/N 76950312) from the CPI through the same conduit
and over to the battery. Refer to the steps and Figure 1-22 on page 1-24 for
instructions on connecting the battery and starter cables.
Note: Be sure to keep the power and communications cables in different pit
conduits.
3 Route the dyno power cable from the CPI to your power source.
Figure 1-21: Route the Eddy Current Brake, Battery, and Power Cables
battery cable
dyno power cable
CPI
eddy current
brake cable
battery
dyno
electronics
route power cables
in designated conduit
starter
starter cable
theta
controller