Pest Control Equipment User Manual

Control Panel Interface Installation and User Guide
CHAPTER 1
Routing Cables
1-18
8 Secure the control panel to the monitor tray using two 8-32-inch screws.
Note: If you did not order a monitor tray, you will need to install the pin plate to
the bottom of your control panel using four 8-32 screws. Once installed, place the
pin on the control panel into the support arm where the monitor tray is.
9 Place the pendant in the slot on the control panel.
10 Route the cable bundle along the support arms with service loops to allow
movement as shown below.
11 Using the provided cable clamps and 8-32-inch screws, attach the cable bundle to
the arms and the support arm. Adjust the service loops to allow for easy
movement of the monitor arms without pulling on the cables.
Figure 1-16: Install the Control Panel
PD031
control
panel
place
pendant
here
CPI
dyno
electronics