Installation Guide

4 2004-2006 KAWASAKI Z750/Z750S
INSTALLATION GUIDE
9 Unplug the stock wiring harness from the injectors.
10 Attach the connectors from the PC6 to the stock
wiring harness and injectors.
Connect the orange colored wires to cylinder #1
(left) and work towards the right.
This image shows cylinder #4 being connected.
11 Locate the primary throttle position sensor on the
right hand side of the throttle bodies.
12 Attach the supplied Posi-tap to the stock YELLOW/
WHITE wire.
13 Attach the GREY wire from the PC6 to the Posi-tap.
Dynojet recommends
using dielectric grease on
these connections.
The wire tap used in this
image is not a Posi-tap.
This is an older crimp-on
style wire tap.
Note: This connection
will be visible, so you may
wish to connect the wire
tap further up the wiring
harness.