Installation Guide

PC6-17050
1 Remove the main seat and the passenger seat.
2 Remove the fuel tank.
This installation can be cone without removing the
fuel tank, but it may be easier to remove the fuel
tank.
3 Remove the fuel line by squeezing the sides of the
connector.
4 Disconnect the two electrical connectors.
5 Lay the PC6 in the tail section.
6 Route the PC6 harness towards the throttle bodies.
Keep the harness between the frame and the tail
section.
7 Route the PC6 harness underneath the fuel tank
bracket.
8 Attach the ground wire from the PC6 harness to the
negative side of the battery.
INSTALLING THE POWER COMMANDER 6