Installation Guide

POWER COMMANDER 6

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

PARTS LIST

IPC6-16077.01

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

Install Guide for: PC6-16077

Model coverage: 2019-2021 Honda CB300R

PAGE 1
POWER COMMANDER 6 Install Guide for: PC6-16077 Model coverage: 2019-2021 Honda CB300R PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-16077.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG OPTIONAL ACCESSORY INPUTS CRANK Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 1 Remove the seat. Remove the side covers. Remove the plastic around the fuel tank. 2 Secure the PC6 module on the back side the air box at the location shown. Use the supplied Velcro strips to secure the module. Clean surfaces with the alcohol swab before attaching the Velcro. 3 Route the PC6 wiring harness forward following along the left side frame rail. 4 Unplug the bike’s ECM. 5 Plug the PC6 wiring harness in-line of the bike’s ECM and stock wiring harness.
PAGE 4
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.