User Manual

13
DX-HTVMM1703-C
www.dynexproducts.com
STEP 5 - Option 2: Install on a solid concrete or concrete block wall
You’ll need
1 Align the center of the wall plate template at the height (a + b) you determined in the previous step, make sure that it is
level, then tape it to the wall.
2 Drill four pilot holes through the template to a depth of 2.4 in. (60 mm) using a 3/8 in. (10 mm) diameter masonry drill
bit, then remove the template.
CAUTION: To prevent property damage or personal injury, never drill into the mortar between blocks. Mount the wall
plate directly onto the concrete surface.
3/8 in.
masonry drill
bit
Wall plate template
B2 (4)
Hammer
B1 (4)
B3 (4)
Wall mount
Magnetic removable
bubble level
Socket wrench
Drill
Edge-to edge
stud finder
Tape
* Minimum solid concrete thickness: 8 in. (203mm)
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
* Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm).
2.4 in. (60 mm)
3/8 in. (10 mm)
Align the center of
the template with
the height mark
(a+b) you made in
STEP 4.
DX-HTVMM1703-C_20-0199_INSTALL_MAN_V6_EN_FR.fm Page 13 Tuesday, September 29, 2020 5:36 PM