Service manual

Trinix NXT — Installation and Service Manual 307
Configuration
Both of these processes are explained in detail below.
From the Individual Output Board Web Page
Follow these steps to configure Output Signal Loss notifications using the
Individual Output board’s Web Page:
1. Click the Signal button to open the Signal Alarm Configuration page
(
Figure 221).
2. Select the Signal alarms for each connector.
Figure 221. The Output Signal Alarm Configuration Page
3. Save the configuration by clicking the Save Signal Alarm Config button
(
Figure 222).
Figure 222. The Signal Alarm Configuration Page
From the Frame Level Signal Web Page
Follow these steps to configure Output Signal Loss notifications using the
Frame level signal’s Web Page:
1. Click the Signal button to open the Frame Info tab (Figure 223).
2. Select the Signal alarms for each connector.