Service manual

306 Trinix NXT — Installation and Service Manual
Section 6 — Broadlinx Software
From the Frame Level Signal Web Page
The Signal Alarm information can be accessed from the Frame Level Signal
Web page.
Follow these steps to configure the Input Signal Loss notification feature
using the Frame level signal’s Web Page:
1. Click the Signal button to open the Frame Info tab (Figure 219).
2. Select the Signal alarms for each connector.
Figure 219. The Signal Alarm Configuration Page
3. Save the configuration by clicking the Save Signal Alarm Config button
(
Figure 218).
Figure 220. The Signal Alarm Configuration Page
Configuring Output Signal Loss Notifications
Output Signal-Loss SNMP notifications are configured using the Broadlinx
Web pages.
The Signal-Loss settings are only available if SNMP is licensed on that
matrix.
The Signal-Loss settings can be accessed from two places.
• From the individual Output Board Web page.
• From the Frame Level Signal Web page.