Service manual

266 Trinix NXT — Installation and Service Manual
Section 5 — Broadlinx Installation
Write down the time displayed for reference.
2. Click the OK button. The Broadlinx: Updating firmware status window
will then appear:
Figure 172. The Broadlinx: Updating Firmware Status Window
The new software will then be copied from the NR-33000 (Broadlinx
board) to each board that requires an update. This process can take
several hours.
When updating systems with two NR boards, the NR performing
the update will not install the software onto itself.
The progress of the installation will be shown by the progress bars on
the Broadlinx: Updating Firmware Status Window and by the alarm
LEDs on the boards that are being updated.
Note When performing a firmware update, the Overall update progress bar indi-
cator will reach and stay at 99% until the update is finished. The update pro-
cedure has not locked up. The Web page will correctly show that the update
is finished when all boards are updated. If the proces is taking 20% longer
than the intitial time shown in Figure 171 on page 265, see The installation
process seems to have stopped on page 283.
If the window is accidentally closed, you can return to it by navigating
to the home page of the Broadlinx card. The rest of the Broadlinx pages
are not available while the update is in progress.
When the progress bars reach 100%, a “finished firmware update”
message will appear.
3. Click the Click here to close this window button (Figure 173 on page 267).