Service manual

Trinix NXT — Installation and Service Manual 185

Output Board Configuration

This adjustment applies to systems with more than one sync reference.

Each output board provides a block of 32 outputs and by factory default,

each block is assigned to sync reference 1. If additional references are used,

DIP switch S5 on each output board is used to assign the board to one of

four possible sync lines.

Figure 100. Sync Reference

Table 36. Sync Reference

Sync line Sync Sel A switch Sync Sel B switch

1 Closed Closed

2OpenClosed

3ClosedOpen

4 Open Open

SYNC SEL A

SYNC SEL B

AUTO RCLK

CLOSED OPEN