Installation manual

TRINIX — Release Notes 9
New Features
Updating Broadlinx Using NetConfig
The steps in this section assume that the latest build has been copied to the
C:\Program Files\Grass Valley Group\Encore\Matrices\Trinix\ folder,
on the PC where the NetConfig application has been installed.
Note Please read the Requirements on page 8 before proceeding.
Follow these steps to update Broadlinx using NetConfig:
1. Start NetConfig and Verify that you are using the 2.0.13 version.
a. Click the About button on the NetConfig tool bar. The About
Network Configuration Tool dialog box will then appear.
b. The version is displayed above the copyright notice. If the installed
version is older than 2.0.13, you will not be able to perform this
update.
c. Click the OK button to close the dialog box.
2. Click the Load Software button on the NetConfig tool bar, or select
Configure > Load Software. A window showing a hierarchy of the
software available will then appear.
3. Click Routers > Encore> Matrices> Trinix (Broadlinx version #) in the
left side window, then select Broadlinx. This will display the software
versions available for loading in the right panel (Figure 1).
Figure 1. NetConfig’s Load Software Window
4. Select the Broadlinx software to be loaded, on the left and then check
the boxes of the matrix controllers to be updated. In the example shown
in Figure 1, only board1 is selected.
5. Select the Re-Boot when complete check box (Figure 1).
6. Click the Load button; the loading dialog will appear (Figure 2 on
page 10). This dialog indicates that the software is being loaded to the
selected boards as well as reporting the update process.
The available
versions of
software