Installation manual

8 TRINIX — Release Notes
Version 3.2.0
New Features
The 3.2.0 version of the Broadlinx software supports the following features:
• Reduced Installation Time
• Support for Updating Broadlinx Using NetConfig
• Support for Protected Paths in Asymmetrical Frames
• Support for the Trinix 128x256 Asymmetric Frame
These features are described in detail below.
Reduced Installation Time
The time it takes to update each board in a Trinix frame during installation
has been reduced. The actual installation time will depend on the size and
configuration of the Routing switcher.
Support for Updating Broadlinx Using NetConfig
Note For more information about the NetConfig application see the NetConfig
Instruction Manual.
The 3.2.0 version of Broadlinx may be copied to the Compact Flash cards
using the 2.0.13 version of NetConfig. Once the flash is updated, the Trinix
matrix web page activate and reboot procedure, as described in
Software
Installation on page 13, will need to be performed to complete the update
process.
Requirements
• The 2.0.13, or newer, version of NetConfig must be used for Broadlinx
Software Update.
• This procedure can be used with the Broadlinx 3.2.0 release and subse-
quent releases. In other words, you will need to manually copy the
entire Broadlinx 3.2.0 file to the Compact Flash disc (CF) if you have the
Broadlinx 3.1.0, and older, release installed.
• This feature cannot be used to downgrade from 3.2.0x to 3.1.0x (or older
releases).
• The Compact Flash should be at least 128MB in size. An error will
appear if a smaller sized flash is used