Installation manual

TRINIX — Release Notes 27
Software Installation
Figure 18. The Restart Caution Popup
CAUTION Clicking the OK button will cause a momentary interruption to video passing
through the Routing switcher. Clicking the Cancel button, while not advised,
will stop the restart process allowing you to restart the board during a sched-
uled service time. However, the new software will not be applied until the
boards are restarted.
6. Click the OK button.
The Post Complete window will then reappear.
7. Activate the other Broadlinx board when the restart process is
completed by pressing the Activate button (see Figure 12 on page 23).
Navigate to the Firmware Management screen there should be a red
light for the Inactive Broadlinx (NR-33000) board
8. Click the Activate button at the bottom of the Firmware Management
page to activate the firmware update for the Inactive Broadlinx board.
9. Restart the Inactive Broadlinx board by pressing the Reset button on the
board.
CAUTION When the Trinix is controlled by Encore, it is imperative that you click the
Re-Sync Matrices button in the Encore application when the newly upgraded
cards are activated. See the Encore Configuration manual for more informa-
tion.