Installation manual

TRINIX — Release Notes 25
Software Installation
Follow these steps to activate the Software:
1. Click the Activate button at the bottom of the Firmware Management
page (Figure 13). The Message from webpage dialog will then appear:
Figure 14. The Estimated Time Dialog
2. Click the OK button. The Broadlinx: Updating firmware status window
will then appear:
Figure 15. The Broadlinx: Updating Firmware Status Window
The new software will then be copied from the active NR-33000 (Broad-
linx board) to each board that requires an update. This process can take
from several minutes to a half an hour or more.
The progress of the installation will be shown by the progress bars on
the Broadlinx: Updating Firmware Status Window and by the alarm
LEDs on the boards that are being updated.
Note If the window is accidentally closed, you can return to it by navigating to the
home page of the Broadlinx card. The rest of the Broadlinx pages are not
available while the update is in progress.
When the progress bars reach 100%, a Finished firmware update
message will appear.
3. Click the Click here to close this window button (Figure 16).