Installation manual

TRINIX — Release Notes 23

Software Installation

Figure 12. NR-33000 (Broadlinx board) Controls.

Note For the Asymmetric frames, the NR-33000 (Broadlinx) board is turned side-

ways, so the Eject button is at the bottom.

2. Insert the Compact Flash card into the slot on both Broadlinx boards

and replace both boards in the frame. Broadlinx will then inventory the

boards that are in the frame.

3. Connect either a serial (for console) or CAT 5 cable (for telnet) to the

router. Open a console (or Telnet) window associated with the Active

NR-33000 board.

4. Type,

sendLoader -1

at the command prompt. The update process will then begin.

Note As the boards are being updated, the alarm light on the board that is being

updated will turn red until the board has been updated.

5. Type: sendLoader 10,<frame #>,0

For Example: sendLoader 10,0,0

Step 5 and Step 6 are used to update the NR-33000 (Broadlinx) boards. The

command in Step 4 updates other boards but the Broadlinx boards.

6. Type: sendLoader 10,<frame #>,1

For Example: sendLoader 10,0,1

Note See the Trinix Frame Slot Maps appendix of the Trinix Installation manual for

maps that identify each slot number for every Trinix Router frame.

Reset button

Activate button

and "Active" LED

Flash module

ector button

NR board

left ejector lever

Flash module