Installation manual

TRINIX — Release Notes 21
Software Installation
Figure 10. The Restart Button on the Firmware Management Screen
The cards must be restarted to use the new firmware.
5. Click the Restart button, which is shown above in Figure 10.
The following Caution pop-up window will then appear:
Figure 11. The Restart Caution Popup
CAUTION Clicking the OK button will cause a momentary interruption to video passing
through the Routing switcher. Clicking the Cancel button, while not advised,
will stop the restart process allowing you to restart the board during a sched-
uled service time. However, the new software will not be applied until the
boards are restarted.
6. Click the OK button.
The Post Complete window will then reappear.