Installation manual

TRINIX — Release Notes 19
Software Installation
Some of the Status lights, in the Status column, will be red following an
installation using a Compact Flash card (
Figure 6). This indicates that the
software that is currently running in the module is different (or older) than
the software that was just installed. The new software should be activated
by following the instructions provided below.
Activating Software
1. Click the Activate button at the bottom of the page (Figure 6). The
Message from webpage dialog will then appear:
Figure 7. The Estimated Time Dialog
2. Click the OK button. The Broadlinx: Updating firmware status window
will then appear:
Figure 8. The Broadlinx: Updating Firmware Status Window
The new software will then be copied from the NR-33000 (Broadlinx
board) to each board that requires an update. This process can take
from several minutes to a half an hour or more.
Note When updating systems with two NR boards, the NR performing the update
will not install the software onto itself.
The progress of the installation will be shown by the progress bars on
the Broadlinx: Updating Firmware Status Window and by the alarm
LEDs on the boards that are being updated.