Installation manual

TRINIX — Release Notes 17

Software Installation

Figure 4. Battery location on the NR-33000.

2. Insert the Compact Flash card into the slot on the Broadlinx board and

then insert the Broadlinx board into the frame. Broadlinx will then

inventory the boards that are in the frame.

Figure 5. NR-33000 (Broadlinx board) Controls.

3. Connect to the active Trinix NR-33000 (Broadlinx) board using a

console session or using a Telnet session.

4. Type, at the command prompt:

sendLoader -1

The update process will then begin.

Note As the boards are being updated, the alarm light on the board that is being

updated will turn red until the board has been updated.

071828316-BATTERY CONNECTION

Battery terminal location

Reset button

Activate button

and "Active" LED

Flash module

ector button

NR board

left ejector lever

Flash module