Installation manual

TRINIX — Release Notes 27
Software Installation
Figure 22. The Firmware Management Screen Broadlinx Status is Red
3. Click the Activate button in the lower right side. The board will be
updated similar to the process described when updating the first board.
4. Navigate to the Firmware Management page. The Restart button will
now appear near the bottom of the page. (The display may vary from
the example that is shown in
Figure 23.)
Figure 23. The Restart Button on the Firmware Management Screen
The cards must be restarted to use the new firmware.
5. Click the Restart button, which is shown above in Figure 23.
The following Caution pop-up window will then appear: